Filter
Top Products
5-16
AS1011M-T2 User's Manual
Overheat LED
Connect an LED to the JOH1 header
to provide warning of chassis over-
heating. See the table on the right for
pin defi nitions.
Overheat LED
Pin Defi nitions (JOH1)
Pin# Defi nition
13.3V
2 OH Active
Power LED/Speaker
On JD1, pins 1, 2, and 3 are for the
power LED and pins 4 through 7 are
for the speaker. See the tables on the
right for pin defi nitions.
Note: The speaker connector pins are
for use with an external speaker. If
you wish to use the onboard speaker,
you should close pins 6 and 7 with a
jumper.
Speaker Connector
Pin Defi nitions (JD1)
Pin# Defi nition
4 Red wire, +5V
5 No connection
6 Buzzer signal
7 Speaker data
PWR LED Connector
Pin Defi nitions (JD1)
Pin# Defi nition
1 +Vcc
2 Control
3 Control
Chassis Intrusion
A Chassis Intrusion header is located
at JL1. Attach the appropriate cable
to inform you of a chassis intrusion.
Chassis Intrusion
Pin Defi nitions (JL1)
Pin# Defi nition
1 Battery voltage
2 Intrusion signal
Wake-On-LAN
The Wake-On-LAN header is des-
ignated WOL. See the table on the
right for pin defi nitions. You must
have a LAN card with a Wake-On-LAN
connector and cable to use the Wake-
On-LAN feature.
Note: Wake-On-LAN from S3, S4, S5
are supported by LAN1. LAN2 sup-
ports Wake-On-LAN from S1 only.
Wake-On-LAN
Pin Defi nitions (WOL)
Pin# Defi nition
1 +5V Standby
2 Ground
3 Wake-up