SUPER MICRO Computer X8DTU-6F+ Computer Hardware User Manual


 
4-2
X8DTU-6F+/X8DTU-6TF+/X8DTU-6(T)F+-LR User's Manual
No Video
If the power is on but you have no video, remove all the add-on cards and 1.
cables.
Use the speaker to determine if any beep codes exist. Refer to the Appendix 2.
for details on beep codes.
System Boot Failure
If the system does not display POST or does not respond after the power is turned
on, check the following:
Check for any error beep from the motherboard speaker. 1.
If there is no error beep, try to turn on the system without DIMM modules. If there
is still no error beep, try to turn on the system again with only one processor in
CPU Socket#1. If there is still no error beep, replace the motherboard.
If there are error beeps, clear the CMOS settings by unplugging the power
cord and contracting both pads on the CMOS Clear Jumper (JBT1). (Refer to
Section 3-7 in Chapter 3.)
Remove all components from the motherboard, especially the DIMM mod-2.
ules. Make sure that the system's power is on and memory error beeps are
activated.
Turn on the system with only one DIMM module. If the system boots, check 3.
for bad DIMM modules or slots by following the Memory Errors Troubleshoot-
ing procedure in this Chapter.
Losing the System’s Setup Con guration
Make sure that you are using a high quality power supply. A poor quality 1.
power supply may cause the system to lose the CMOS setup information.
Refer to Section 2-6 for details on recommended power supplies.
The battery on your motherboard may be old. Check to verify that it still sup-2.
plies ~3VDC. If it does not, replace it with a new one.
If the above steps do not x the Setup Con guration problem, contact your 3.
vendor for repairs.