SUPER MICRO Computer X8DTU-6F+ Computer Hardware User Manual


 
Chapter 5: AMI BIOS
5-25
Gateway Address (When IP Address Source is set to 'Static')
The BIOS will automatically enter the Gateway address for the system when the
IP Address Source is set to 'Static'. It can also allow the user to set a Gateway
address for the system If the IP Address Source is set to "DHCP". However,
the Gateway address may be overwritten. The value of each three-digit number
separated by dots should not exceed 255.
MAC Address (When IP Address Source is set to 'Static')
The BIOS will automatically enter the MAC address for the system when the IP
Address Source is set to 'Static'. It can also allow the user to set an MAC ad-
dress for the system If the IP Address Source is set to "DHCP". However, the
MAC address may be overwritten. Mac addresses are 6 two-digit hexadecimal
numbers (Base 16, 0 ~ 9, A, B, C, D, E, F) separated by dots. (i.e., 00.30.48.
D0.D4.60).
BMC Watch Dog Timer Action
Allows the BMC to reset or power down the system if the operating system hangs
or crashes. The options are Disabled, Reset System, Power Down, Power Cycle.
If the feature is not set to Disabled, the following item will display.
BMC Watch Dog TimeOut [Min:Sec]
This option appears if BMC Watch Dog Timer Action (above) is enabled. This
is a timed delay in minutes or seconds, before a system power down or reset
after an operating system failure is detected. The options are [5 Min], [1 Min],
[30 Sec], and [10 Sec].
Event Log Con guration
View Event Log
Use this option to view the System Event Log.
Mark All Events as Read
This option marks all events as read. The options are OK and Cancel.
Clear Event Log
This option clears the Event Log memory of all messages. The options are OK
and Cancel.
PCIE Event Log
Select Yes to activate and display the PCI-Express slot event log. The options are
Yes and No.