Filter
Top Products
November 2001 Synopsys, Inc. 27
The ModelSource 640-pin Adapter Chapter 5: Completing the Model
Unmounting the Adapter from the
ModelSource Modeling Systems
To remove the Adapter from the ModelSource modeling systems, follow these steps:
1. Ensure that the Adapter is not currently in use (that is, the In Use LEDs are not
illuminated).
2. Turn each knob individually clockwise, to unseat each modeling board connector
from the Adapter.
3. Verify that the “Seated LED” on each modeling board is no longer illuminated.
4. Push the Adapter so that it is flush against the front panel of the modeling system
assembly, and slide it up as far as you can.
5. Pull the Adapter straight out and away from the modeling system assembly.