Filter
Top Products
7.1 Analog Set-up
The diagram shows how to connect a 7.1 SDDS
™
analog set-up.
The Centre monitor is set as the System Controller by leaving
out the TC Link button on the rear panel.
RJ45 Network connections for the system should be connected
in the following way: -
Centre output to LF input
Centre output to RF input
LF output Sub input
Sub output to LI input
LF output to LS input
LI output RI input
RF output to RS input
The Centre monitor receives audio for both centre (input 1) &
LFE channels (input 2) via the analog input connectors.
The LF monitor receives audio for both LF (input 1) & LS channels
(input 2) via the analog input connectors.
The LI monitor receives audio for both LI (input 1) & RI channels
(input 2) via the analog input connectors.
The RF monitor receives audio for both RF (input 1) & RS channels
(input 2) via the analog input connectors.
When no Bass management is selected, only the LFE signal will be sent to the subwoofer.
When Bass management is selected, low frequency content from the 5 main channels is extracted and sent to the
subwoofer where it is summed with the LFE channel. (Only LF, Center, RF, LS, and RS contribute to the bass
management signal.).
The iDP
™
Remote, iDP SOFT
™
or PC-iP
™
can be connected to any spare TC Link “out” connection.
! REMEMBER – To set a master monitor as the system controller the TC Link button on the rear panel
MUST be in the out position.
7.1 Digital Set-up
The diagram shows how to connect a 7.1 SDDS
™
digital set-up.
The Centre monitor is set as the System Controller by leaving out
the TC Link button on the rear panel.
RJ45 Network connections for the system should be connected
in the following way: -
Centre output to LF input LF output to LS input
Centre output to RF input LI output RI input
LF output Sub input RF output to RS input
Sub output to LI input
The Centre monitor receives audio for both centre & LFE channels
via the AES input connector (input 2).
The LF monitor receives audio for both LF & LS channels via the
AES input connector (input 2).
The LI monitor receives audio for both LI & RI channels via the
AES input connector (input 2).
The RF monitor receives audio for both RF & RS channels via the
AES input connector (input 2).
When no Bass management is selected, only the LFE signal will be sent to the subwoofer.
When Bass management is selected, low frequency content from the 5 main channels is
extracted and sent to the subwoofer where it is summed with the LFE channel. (Only LF, Center,
RF, LS, and RS contribute to the bass management signal.).
The iDP
™
Remote, iDP SOFT
™
or PC-iP
™
can be connected to any spare TC Link “out” connection.
! REMEMBER – To set a master monitor as the system controller the TC Link button on the rear
panel MUST be in the out position.
21