Teac CD-W28PU Computer Drive User Manual


 
82
ENGLISH
6. System Recovery Procedure
6.3 System recovery of Windows 2000 and Windows XP
1. Prepare four formatted floppy disks.
2. Insert Windows CD into the CD-ROM drive or the CD-W28PU of
your computer.
3. Run the Makeboot.exe file in the Bootdisk Folder.
4. MS-DOS prompt appears on tthe screen of your PC.
5. Make the Startup disks according to the instruction of the O/S.
6. Open the Txtsetup.sif file in the 1st disk of the Startup disks, then
search the parameter of USB\VID_0644&PID_0000 = usbstor.
It is convenient to use the Find function of the Edit menu to find
the parameter easily. Use 0644 for the Find..
7. Add following parameter just under the line of
USB\VID_0644&PID_0000 = usbstor.
USB\VID_0644&PID_1002 = usbstor.
8. Save the file.
9. Your original Startup Disks are completed. Please keep it until the
case of emergency
10.In the case of emergency and if you need to make the system re-
covery from Windows CD, insert the 1st Startup Disk into the FDD
of your computer.
11.Boot up your computer from FDD, not from HDD.(You may need to
change BIOS setup. Please refer to the users manual of your com-
puter.)
12.Follow the instructions of your O/S.
Confirm that the drive is directly connected to your com-
puter, and not via either an USB hub or an USB host
adapter when implementing the System recovery.
When using the recovery driver disc in the USB floppy
disk drive, be sure that the drive and the USB floppy
disk drive are directly connected to your computer, and
not via either an USB hub (two or more USB connec-
tors are required in your computer) or an USB host
adapter.
C a u t i o n
C a u t i o n