Filter
Top Products
3-24
Chapter 3: SYSTEM SETTINGS (NX-100 SETUP PROGRAM)
Step 4. Set the type to [Momentary] or [Latch].
Momentary: The designated broadcast pattern or other unit's contact output is activated during the
interval that input is ON. Activation stops while the input is OFF.
Latch: The designated broadcast pattern or other unit's contact output is activated when the
input is turned ON, and the activation mode continues even if the input is turned OFF.
Activation stops when the input is turned ON again.
50 ms or more
50 ms or more
Broadcast and
contact data
Contact input
Contact input
• Latch
Broadcast and
contact data
Contact input
Contact input
Make
Break
Make
Break
• Momentary
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
A
c
tiv
a
ti
o
nStop
A
c
tiv
a
ti
on
Stop
Step 5. Set Polarity to [Make] or [Break].
Make: ON when the contact is closed.
Break: ON when the contact is opened.
Step 6. A list of the programmed broadcast patterns is displayed in the [Broadcast pattern] screen. Tick the
checkbox to select the pattern.
Cautions
• Broadcasts cannot be made if the set frequency band exceeds the usable bandwidth.
• Up to 4 broadcast patterns can be selected for transmission, and 1 pattern for reception. (Only 1
pattern for multicast streaming.)
• When no broadcast pattern is displayed, no broadcast patterns are programmed. In such cases,
create new patterns on the Broadcast Pattern setting tab screen.
Step 7. Click to select the connected unit from the [Contact bridge unit] list.
Cautions
• Only those units connected to the LAN can be selected.
• Up to 64 locations can be selected.