Filter
Top Products
Before performing the setting using the Operation program
Set the NX-100 and NX-100S units in the system using the NX-100 Setup program.
Broadcast settings that will be activated by the operation program must all be programmed into each
connected unit as the "broadcast pattern."
5-5
Chapter 5: OPERATION SETTINGS (NX-100 OPERATION PROGRAM)
5. SETTING PROCEDURES USING THE OPERATION PROGRAM
(1) Add the unit to the system.
NX-100 and NX-100S units set with the Setup program as system units are automatically
recognized as operable units by the NX-100 Operation program. NX-100 and NX-100S
units which were set without using the NX-100 Setup program, such as the units
connected through the Internet, can be added to the system setting using the NX-100
Operation program.
(3) Set the Selection buttons.
Set the Selection buttons that select the broadcast patterns or contact outputs to be activated.
Use the broadcast patterns which were programmed into the operable units (those units set with the
NX-100 Setup program and added in Step (1) above).
Only one pattern can be programmed into each Selection button.
When simultaneously activating two or more broadcast patterns with the Group button, all of the
broadcast patterns to be activated must first be programmed into the Selection buttons.
(4) Set the Group buttons.
Use the Group button when wishing to simultaneously activate two or more broadcast patterns. Select
and assign the desired Selection buttons to each Group button.
If the system contains NX-100 and NX-100S
units not set with the Setup program such as
the units connected through the Internet.
If only NX-100 and NX-100S units
set with program are used.
If simultaneously activating multiple
broadcast patterns
The NX-100 Setup program cannot be used to set NX-100 and NX-100S units connected
via the Internet.
(2) Set the Button layaout.
Edit the Button layout.
Edit the layout of the Selection and Group buttons on the operation screen.