Filter
Top Products
3-27
Chapter 3: SYSTEM SETTINGS (NX-100 SETUP PROGRAM)
6.7. Serial Bridge Setting
Step 1. Click on the [Serial] tab of the System Setting Tool.
Step 2. Tick [Enable serial port].
The setting screen will be displayed, allowing entry of each item.
NX-100 only
Step 3. Set each item.
(1) Protocol
Select the serial bridge communication method.
TCP server: The unit selected on the setting screen functions as a TCP server and carries out
communications.
TCP client: The unit selected on the setting screen functions as a TCP client and carries out
communications. Clicking the radio button permits selection of the connected unit.
UDP: Carries out UDP communications. Clicking the radio button permits selection of the
connected unit.
(2) Target unit
Select the unit to be connected.
Caution
Only units connected to the LAN can be selected.