22
2. “ ” or ENTER is the Enter button.
(a) Press and hold the Enter button for at least 2 seconds to read the parameter
settings of the UPS. Press the Enter button again to cycle through each successive
parameter.
(b) Ten seconds of inactivity will return the display to the original status.
3. “ ” or FUNC is the Function button.
(a) Press and hold the Function button for at least 2 seconds to access the selectable
parameters. Press the Function button again to cycle through each successive
selectable parameter.
(b) Press the Enter button to view or change the displayed parameter.
(c) Ten seconds of inactivity will return the display to the original status.
4. STATUS (2400/6000VA Only) will display the UPS data.
(a) Press and hold the Status button for at least 2 seconds to read the parameter
settings of the UPS. Press the Enter button again to cycle through each successive
parameter.
(b) Ten seconds of inactivity will return the display to the original status.
5. ESCAPE (2400/6000VA Only) – Press Escape to return to the main display
immediately.
7.3 Control Panel Functions
The front panel is composed of five LED indicators, an LCD screen, and a speaker for
audible alarms.
Rack-mounted units have international symbols stenciled next to the LED indicators
instead of text.
ON/OFF or — is on when the UPS is turned on (green).
ON-LINE or — is on when in the Normal or Static Bypass modes. Also
indicates that there is voltage at the output terminals (green).
ON-BAT or — is on while operating in the Battery mode.
BYPASS or — is on while operating in the Bypass mode (yellow).