Filter
Top Products
6. PRINTER OPERATION
EO1-33032
6.2 Installing the Printer Drivers
6- 2
6.2.1 System Requirements
6.2.2 Driver Installation
1.
System
a. IBM Compatible PC running Windows 95® or Windows 98® or
Windows NT® Version 4.0 Workstation, Windows NT® Version
4.0 Server, Windows 2000® Professional, or Windows 2000®
Server.
b. Pentium® processor, 133MHz or greater recommended.
c. Installed memory of 16MB minimum (32MB recommended).
d. Available Hard Disk space of 10MB or more.
2.
Interface
a. The RS-232C interface
b. Centronics interface
1.
Insert the supplied CD-ROM into the CD drive of your PC.
2.
Click on the
START
button, then select and click on the
Run…
.
3.
Type in ‘D:\DRIVER\SETUP.EXE” and click on the
OK
button.
(“D” may be replaced with your CD drive’s letter.)
4.
The screen will change as shown below.
5.
After the Install Shield temporary files have been loaded, the display
will change to the Welcome screen as shown below.
NOTE:
Windows 3.1® is not supported.
Windows 3.1®, Windows 95®,
Windows 98®, Windows NT®
,
and Windows 2000 ®
are
registered trademarks of
M
icrosoft Corporation.
Pentium® is a registered trade-
mark of Intel Corporation
NOTE:
1. How to install the printer
driver from the supplied CD-
ROM is described below.
2. When the printer driver is
downloaded from TOSHIBA
TEC Web Site, type in
“C:\TEC\MONO\CD\SETUP
.EXE”. C:\TEC\MONO\CD
is the default install directory
generated when the printer
driver file
(Bdrv_Vx_x_Buildxx.exe) is
run.