Filter
Top Products
APPENDIX 4 SYSTEM MODE
EO1-33032
A4.4 Self-Diagnostic Test
A4- 4
A4.4 Self-Diagnostic
Test (Cont.)
While in a Pause condition press and hold the
[RESTART]
key until
“<0>RESET” appears in the display.
Then, press the
[FEED]
key, and “<1>DIAG. Vx.x” message appears.
Ribbon type selection
Press the
[PAUSE]
key. The ribbon type can be selected:
“NO RIBBON” (Direct Thermal Paper), “TRANS.” (Transmissive
ribbon), or “NO TRANS.” (Non transmissive ribbon).
After selecting the ribbon type, press the
[PAUSE]
key to confirm and
go to Maintenance counter and Parameter settings print out.
Maintenance counter/parameter settings print out
The printer will print out the Maintenance Counter and Parameter
Settings. Press the
[PAUSE]
key to start.
The printer starts printing out the Maintenance Counter & Parameter
Settings.
After printing is completed, the display returns to “<1>DIAG. Vx.x”.
Self-Diagnostic Test and the result print out
After the Maintenance Counter and Parameter Settings print out has been
completed, the display returns to “<1>DIAG. Vx.x”. Press the
[PAUSE]
key twice then
[FEED]
key once.
The Self-Diagnostic Test is ready. Press the
[PAUSE]
key to start.
The printer starts the Self-Diagnostic Test, and prints out the result.
After printing is completed, the display returns to “<1>DIAG. Vx.x”.
NOTE:
When using a ribbon, be sure to
select “TRANS” or “NO
TRANS.”. When using direct
thermal media, be sure to select
“NO RIBBON”.
NOTE:
See Section A4.8.2 for a
M
aintenance Counter and
Parameter Settings print
sample and a detailed
descri
p
tion
f
or each item.
NOTES:
1. If an error occurs, an
error message appears,
and the printer stops
printing. After clearing
the error, press the
[PAUSE]
key to return to
“<1>DIAG.”. The
printer does not resume
printing automatically.
2. See Section A4.8.1 for
Self-Diagnostic Test Print
sample and a detailed
description of each item
.
Transmissive ribbon
Non transmissive ribbon
[RESTART]
[FEED]
Direct thermal paper