Filter
Top Products
7. SUPPLY SPECIFICATIONS ENGLISH VERSION EO1-33056
7.1 Media
E7- 2
7.1.2 Detection Area of the Transmissive Sensor
The detection range of the Transmissive Sensor of the movable sensor is 70 mm from the media edge.
The Transmissie Sensor of the fixed sensor is positioned at 10 mm from the centre of media.
The Transmissive Sensor detects a gap between labels, as illustrated below.
<Label>
<Tag paper with square holes>
N
OTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified media.
2. The ratio of a label length to a gap length must be a minimum of 3 to 1 (3:1).
3. Backing paper must be wider than a label; the distance between the edge of the backing paper and that of a label
should be at least 1.5 mm.
4. When using a label stock in cut mode, be sure to cut the gaps. Cutting labels will cause the glue to stick to the
cutter, which may affect the cutter performance and shorten the cutter life.
5. To tear off printed media in batch issue easier, set the Auto Forward Wait function (FORWARD WAIT
parameter) to ON in the system mode. When this function is effective, the printer stops feeding the printed media
past the strip shaft. In case of a label stock, however, if a next label is issued without tearing off the printed label,
the label may peel while it is fed backward, causing a printer failure.
Sensor position
A
rea to be detected.
Centre of media
Print side
Min. 12 mm
Label
Gap
Label
Min. 2.5 mm
70mm
Movable Sensor
Media feed direction
Sensor position
Centre of media
Min. 12 mm
Media feed direction
Min. 2.5 mm
Square holes
(Round holes are not acceptable.)
Print side
10mm from the centre
Fixed Sensor
70mm
Movable Sensor
10mm from the centre
Fixed Sensor