Filter
Top Products
Appendix 1 Specifications
76
The formula below shows the relation between paper roll length and
paper core diameter.
L =
4 t
(D
2
-d
2
) π
L : Paper length
D : Paper roll diameter
d : Paper core outside diameter
t : Paper thickness
(π= 3.14...)
For calculation, the units of the factors must be the same.
The Transmissive Sensor is movable from the center to the left edge
of media.
The Transmissive Sensor detects a gap between labels, as illustrated
below.
A1.3.2 Detection Area of the
Transmissive Sensor
The Transmissive Sensor detects a hole on a roll of tags, as illustrated
below.
Note:
This printer does not support a roll
of tags with round holes.
Area to be detected
Sensor Position
Label
Gap
Label
Min. 12mm
Min. 2.0mm
(Min. 6.0mm with the
Cutter Module installed)
Sensor Movable
within this range
Image printed
on this side
Center of Media
Media Feed
Direction
Sensor Position
Rectangular Hole
Min. 2.0mm
Min. 12mm
Center of Paper
Image printed
on this side
Media Feed
Direction
Sensor movable
within this range
A1.3.1 Media Type (Cont.)