Filter
Top Products
Appendix A4 Message and LED
86
Appendix 4 Message and LED
Appendix 4 describes the messages displayed on the Operation Panel.
Symbols in the Message
1
: The LED illuminates. : The LED is flashing. : The LED is turned Off.
2
####: Remaining label count Up to 9999 (in pieces)
3
%%%: Remaining memory capacity for storing writable characters and logos 0 ~ 715 (in K bytes)
4
*: Print head block that has a problem.
1: Head 1 (Back) 2: Head 2 (Front)
No.
POWER ONLINE ERROR
Printer Status
LCD Messages
ON LINE
LED Indication
In Online Mode
In Online Mode
(The printer in communication)
The print head was opened in Online
Mode.
The printer is paused.
A parity error, overrun error or
framing error has occurred during
communication through RS-232C.
The media is jammed during paper
feed.
A problem has occurred at the Cutter
Module.
The media has run out, or the media
is not loaded on the Supply Shaft
Holder properly.
The ribbon has run out, or has been
torn.
A problem has occurred with the
sensor that determines the torque for
the ribbon motor.
Feed or printing was attempted with
the print head open.
The print head is overheated.
The cover was opened in Online
Mode.
Feed or printing was attempted with
the print head open.
The Pinch Roller Unit is not locked
in Online Mode.
Feed or printing was attempted with
the Pinch Roller Unit unlocked.
The power supply unit is overheated.
In writable character or logo save
mode
- YES
- YES
- YES
YES YES
YES YES
YES YES
YES YES
YES YES
YES YES
YES YES
NO YES
YES YES
YES YES
YES YES
YES YES
NO YES
- YES
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
ON LINE
HEAD OPEN *
PAUSE
COMMS ERROR
PAPER JAM ####
CUTTER ERROR####
NO PAPER ####
RIBBON ERR.####*
HEAD OPEN ####*
EXCESS HEAD TEMP
COVER OPEN
COVER OPEN ####
PAPER SET ERROR
PAPER ERROR ####
EXCESS P/S TEMP
SAVING %%%
Restoration
by RESTART
key Yes/No
Acceptance of
Status Request
Reset Command
Yes/No