Filter
Top Products
General Precautions 21
General Precautions
When installing or moving
Warning
y This Multifunctional Digital Colour Systems requires 220 to 240 V AC, 8 A 50/60 Hz electric
power.
Do not use a power supply with a voltage other than that specified.
Avoid multiple connections in the same outlet. This could cause a fire or give you an electric
shock. If you are considering increasing the number of outlets, contact an electrician.
y Always connect this Multifunctional Digital Colour Systems to an outlet with an earth connec-
tion to avoid the danger of fire or electric shock in case of short-circuiting. Contact your ser-
vice representative for the details. Be sure to use a 3-conductor, grounded wall outlet.
In areas, except U.S. and Canada, where a 2-pin plug is used, the Multifunctional Digital
Colour Systems must be grounded for safety. Never ground it to a gas pipe, a water pipe, or
any other object not suitable for grounding.
y Plug the power cord securely into the outlet. If it is not plugged in properly, it could heat up
and cause a fire or give you an electric shock.
y Do not damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
- Twisting it
- Bending it
- Pulling it
- Placing anything on it
- Making it hot
- Situating it near radiators or other heat sources
This could cause a fire or give you an electric shock. If the power cord is damaged, contact
your service representative.
y When removing the plug from the outlet, do not pull the power cord. Always hold the plug
when removing it from the outlet. If the power cord is pulled, the wires may become broken
and this could cause a fire or give you an electric shock.
y Make sure that the ventilation holes are not blocked up.
If the temperature within the Multifunctional Digital Colour Systems becomes too high, a fire
could result.
y Do not move the Multifunctional Digital Colour Systems to another building, up and down the
stairs or for any great distance.
This could cause an injury or give you and electric shock. When lifting or moving the Multi-
functional Digital Colour Systems, contact your service representative.
y Do not move the Multifunctional Digital Colour Systems with optional equipment, such as the
finisher, attached.
This could cause a fire or give you an electric shock. When lifting or moving the Multifunc-
tional Digital Colour Systems, contact your service representative.
y When moving the Multifunctional Digital Colour Systems, be sure to shut down the power
prior to pulling out the plug from the outlet. If the power cord is damaged, this could cause a
fire or give you an electric shock.
y The socket outlet shall be near the equipment and be easily accessible.
y Pull out the plug from the outlet more than once a year to clean around the prongs. Accumu-
lating dust and dirt could cause a fire due to the heat released by electric leakage.