Filter
Top Products
– 50 –
EO1-11113
PLU Programmed Data Copying
This operation is used to copy the programmed data of a PLU item and to use it in programming an-
other PLU item, thus eliminating time in PLU programming operation.
To program new PLUs or to change any programmed contents of PLUs:
Any time outside a sale (except the following case)
To change the PLU of the copy-destination with sales data not zero:
After PLU Reset
Mode Lock: SET
ex.) To program PLU 90701 (7-up Small-B) again that was once
programmed and then deleted, by copying the programmed data
of PLU 90601 (Coke Small-B):
Mode Lock: SET, enter 4, depress [X]
90701 [PLU] (PLU Code of the copy-destination)
[NS]
90601 [PLU] (PLU Code of the copy-source)
2 [ST] 7-up Small-B [ST]
(Address 2, Name changed into: 7-up Small-B)
9 [ST] 7 [#] (Address 9, PLU Group No. changed into : 7)
[AT/TL] (to end this submode)
4 [X]
| PLU Code of the copy-destination | [NS]
| PLU Code of the copy-source |
The programmed data of the copy-source PLU is now copied
to the copy-destination PLU (except the PLU Code). Then
follow the procedure on the page of Programming or
Changing to change data of any required Addresses.
[PLU]
[PLU]
P 0 4
090701
2
#00 090601
#02 7-up Small-B
#09 07
00030
0030
TEC STORE
1343 PEACH DRIVE
PHONE : 87-6437
Open 8:00am to 7:00pm
Closed : every Wednesday
11-14-1994 MON #1
OPERATION
CONDITION