– 58 –
EO1-11113
PLU PRESET-CODE KEY SETTING (Submode 27)
When there are any keys programmed as PLU Preset-code Keys on the ECR Keyboard, and/or when
the PLU Keyboard PK-2 (hardware option) is connected to the ECR, a PLU code may be preset to each
of those keys in this operation.
Any time outside a sale
Mode Lock: SET
Repeat for other keys.
NOTES: 1. If the PLU Code entry is skipped and a [KEY] is simply depressed in the above
sequence, the preprogrammed PLU Code of the KEY will be displayed.
2. A non-opened PLU Code (i.e. PLU non-existent in the PLU table file can be set on a
KEY, however, pressing the KEY in sale entries will result in an error unless the code
is opened in the PLU TABLE PROGRAMMING operation. Submode 4.
3. If “0” is entered as PLU Code in the above sequence, the KEY will be closed. Press-
ing the closed KEY in sale entry will cause an error.
4. The designation of the keyboard phase No. is omissible. In this case, the PLU code
is automatically programmed on the keyboard phase No. 1.
This designation is unavailable to the PK-2.
ex.) To set the following PLU Codes to KEYS on the ECR keyboard:
PLU Code
50321
50322
27 [@/FOR]
| Keyboard phase No. | [ST]
[KEY]
[AT/TL]
Enter through Numeric
Keys on the ECR
Keyboard
(Enter 0 to close the key);
Max. 6 digits
1 to 3;
See NOTE 4 below
Mode Lock to SET.
27 [@/FOR]
50321 [required key]
50322 [required key]
[AT/TL]
P 2 7
#073 050321
#074 050322
0017
TEC STORE
1343 PEACH DRIVE
PHONE : 87-6437
Open 8:00am to 7:00pm
Closed : every Wednesday
12-19-1994 MON #1
OPERATION
CONDITION
| PLU Code |
Depress the required key on
the ECR Keyboard or on the
PK-2 Keyboard.
Location Code (left side): refer to REMARKS 1 and 2 on
the next page.
PLU Code assigned to the key (right side)