Filter
Top Products
- 12 -
EO1-11113
Process Reports available
PROCESS REPORTS AND BASE REPORT DATA
The following table shows which process reports are available after which report data collections.
Reports Collection Required before Process
Report takings
(CONSOLIDATION MEMORY CAPTURE: NOTE 1)
All Department Read Daily Individual Department Read Daily
or
All Department Reset Daily
All Department Read GT Individual Department Read GT
or
All Department Reset GT
Any of the following PLU reports (NOTE2) Individual PLU Read Daily
Inactive PLU Read Daily
All PLU Read Daily
Zone PLU Read Daily
All PLU Reset Daily
Zone PLU Reset Daily
Any of the following PLU reports (NOTE2) Individual PLU Read GT
Inactive PLU Read GT
All PLU Read GT
Zone PLU Read GT
All PLU Reset GT
Zone PLU Reset GT
NOTES: 1) CONSOLIDATION MEMORY CAPTURE: When an in-line read or reset report is
taken on the Master Terminal, the consolidated data is automatically stored in the
Consolidation Memory of the Master Terminal. The consolidated data stored there is
not only used as the data for a Process Report but also sent to the PC by a command
from the PC when a PC is connected.
2) The process reports will be outputted based on the report data previously collected.
For example, when an “Inactive PLU Read” report is taken after a “Zone PLU Read”,
only the inactive PLUs in the designated zone will be printed on the Inactive Read
Report. (Only when the PLU is in a local file, a process report is printed. In this case,
collection of data is required beforehand.)
3) When individual department reading (daily/GT) is performed, press the [OPEN] key
before performing all department reading (daily/GT). Then, only the consolidated data
is created to output the process report.