Filter
Top Products
User’s Manual 7-4
HW Setup
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6, Retaining
data with power off.
Built-in LAN
This feature enables or disables the Built-in LAN.
SATA
eSATA
This feature allows you to set conditions for SATA.
SATA Interface setting
This feature allows you to set SATA interface setting.
■ The Wake-up on LAN function consumes power even when the
system is off. Leave the AC adaptor connected while using this
feature.
■ Regarding Wake-up on LAN from sleep or hibernation, you must check
the "Allow the device to wake the computer" check box within the LAN
Device properties. (This feature does not effect the Wake-up on LAN
from sleep or hibernation.)
Enabled
Enables Wake-up on LAN from shutdown.
Disabled
Disables Wake-up on LAN from shutdown.
(Default)
Enabled
Enables Built-in LAN functions (Default).
Disabled
Disables Built-in LAN functions.
Enabled
Enables the eSATA port. (Default)
Disabled
Disables the eSATA port in order to save power.
Performance
Let HDD/SSD work with maximum performance.
(Default)
Battery life
Let HDD/SSD work with battery life mode. If this
setting is selected, this caused performance
down.