Filter
Top Products
6-14 Satellite M100
Power and Power-Up Modes
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3, Getting Started. The
following message will appear in the LCD:
Enter Password [xxxxxxxx]
2. Enter the Password.
3. Press Enter.
Power-up modes
The computer has three power-up modes:
■ Hibernation (saves data in memory to the hard disk)
■ Standby (power remains on, maintaining the data in memory, but the
CPU and all other devices effectively enter a 'sleep' mode)
■ Boot (does not save data in memory)
Panel power off/on
This feature makes the computer to enter Hibernation when the display
panel is closed and turns it back on when the display panel is opened.
System automatic Standby/Hibernation
This feature automatically turns off the system in Standby or Hibernation
mode if the computer is not used for a set duration.
Refer to Special features, in Chapter 1, Satellite M100 Features for an
explanation of how to set the duration.
At this point, the hotkeys Fn + F1 to F9 do not work. They will function after
you enter the password.
If you enter the password incorrectly three consecutive times, the computer
shuts down. You must turn on the computer again and re-enter the
password.
Refer also to the section Turning off the power in Chapter 3, Getting Started.
If the panel power off function is enabled and you use Shut down Windows,
do not close the display until the shut down function is completed.