Filter
Top Products
4-6 Satellite M100
Operating Basics
7. The User’s Fingers screen is displayed. Based on the illustration, select
the finger to be recognized, and then click Next. Previously enrolled
fingerprints would have green check marks. The fingerprint being
enrolled now would have a red check mark. If any of the previously
enrolled fingerprints is selected again, the latest information will be
enrolled and previous information over-written.
8. The Capture Fingerprint screen is displayed. Follow the onscreen
instructions and use the same finger you have selected under Choose
Finger to swipe three times to allow the sensor to read the fingerprint.
The fingerprint will be shown in green if properly read, or in red if the
reading is abnormal.
9. The Verify Fingerprint screen is displayed. Swipe the finger again to
allow the sensor to read again. When the Verification Successful
message is displayed, click Next.
In case of finger injury or authentication failure, it is recommended that
another fingerprint also be enrolled. The following message will be
displayed:
"It is recommended that you enroll at least two fingers. Would you
like to enroll an additional finger now?"
Click Yes and repeat steps 3, 4 and 5 with another finger.
10. The Advanded Security screen is displayed. Select whether to enable
the security function, and click Next.
11. The Finalization screen is displayed. Click Finish. This completes the
fingerprint registration process.
Window Logon via Fingerprint Authentication
In place of the usual Windows logon by ID and password, fingerprint
authentication also allows logon to Windows.
This is useful especially when many users are using the PCs, as user
selection can be skipped.
Fingerprint Authentication Procedure
1. Start up the computer.
2. The Logon Authorization screen is displayed. Choose any of the
enrolled fingers and swipe the fingerprint on the sensor.
If authentication is successful, the user will be logged on to Windows.
If the fingerprint authentication fails, please logon using the Windows logon
password.
Please logon using the Windows logon password if the fingerprint
authentication failed for three consecutive tries. To logon using the Windows
logon password, enter the Windows logon password at the Welcome
screen as normal.
A warning message will be displayed when authentication is abnormal or
authentication is not successful within a fixed duration.