Filter
Top Products
Satellite M100 4-31
Operating Basics
When Using WinDVD Creator 2 Platinum
How to make a DVD-Video
Simplified steps for making a DVD-Video from video data captured from a
DV-Camcorder:
1. Click Start -> All Programs -> InterVideo WinDVD Creator2 ->
InterVideo WinDVD Creator to launch WinDVD Creator.
2. Click the Capture button then capture the video data from the DV-
Camcorder via the IEEE1394 connection.
3. Click the Edit button then drag the video clips from Video Library tab
to the edit track.
4. Click the Make Movie button in the top bar.
5. Double-click the right arrow button icon in the center of the right hand
side.
6. Put a blank DVD-R/+R disc or an erased DVD-RW/+RW disc in the drive.
7. Click Start to record to the disc.
8. When recording is finished, the tray opens.
How to learn more about InterVideo WinDVD Creator
Please refer to the on-line Help for additional InterVideo WinDVD Creator
information.
Important information for use
Note the following limitations when you write video DVD:
1. Editing digital video
■ Log in with Administrator rights to use WinDVD Creator.
■ Make sure that your computer is running on AC power when using
WinDVD Creator.
■ Operate the computer at Full Power. Do not use power-saving features.
■ While you are editing DVD, you can display previews. However, if
another application is running, the preview might not display properly.
■ WinDVD Creator cannot show video on the RGB (Monitor) when in
simultaneous mode.
■ WinDVD Creator cannot edit or play copy protected content.
■ Do not change display settings while using WinDVD Creator.
■ Do not enter standby/hibernation mode while using WinDVD Creator.
■ Do not operate WinDVD Creator immediately after turning on the
computer. Please wait until all Disc Drive activity has stopped.
We pre-install WinDVD Creator.