Filter
Top Products
User’s Manual 3-29
Hardware, Utilities and Options
Installing a memory module (Slot B)
To install a memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning off the power section in
Chapter 1, Getting Started if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
the Replacing the battery pack section in Chapter 6, Power and Power-
Up Modes, if required).
5. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-15 Removing the memory module cover
Always make sure the display panel is closed in Laptop mode before
turning the computer upside down.
Use a point size 0 Phillips screwdriver.
Screw
Memory
module cover