Filter
Top Products
G-3
A
PPENDIX
G
When installing Wireless LAN cards, the channel configuration is managed as
follows:
For wireless clients that operate in a Wireless LAN Infrastructure, the Wireless
LAN card will automatically start operation at the channel identified by the
Wireless LAN Access Point. When roaming between different access points
the station can dynamically switch to another channel if required.
For Wireless LAN cards installed in wireless clients operating in a peer-to-peer
mode, the card will use the default channel 10.
In a Wireless LAN Access Point, the Wireless LAN card will use the factory-
set default channel (printed in bold), unless the LAN Administrator selected a
different channel when configuring the Wireless LAN Access Point device.
Wireless IEEE 802.11 Channels Sets (Revision A)
Frequency Range Channel ID 5150-5850 MHz Note
36 5180
40 5200
44 5220
48 5240
52 5260
56 5280
60 5300
64 5320
149 5745 US only *
153 5765 US only *
157 5785 US only *
161 5805 US only *
* Available Area: US (USA, CANADA) only
A peer-to-peer mode is available under the following condition:
A Wireless LAN card receives a “US county/region code” beacon of the standard IEEE
802.11 (Revision D) from a Wireless LAN Access Point.
Appendix G