Filter
Top Products
Chapter 2 Troubleshooting Procedures
Satellite T130, Satellite Pro T130 and PORTEGE T130Maintenance Manual (960-Q08)
Procedure 1 Message Check
When the power is turned on, the system performs the Power on Self Test (POST) installed
shown on the display, perform Check 1.
If t r rocedure 2.
If Free-DOS or W .
Check 1 If one of the following error messages is displayed on the screen, press the F2 key
as the message instructs. These errors occur when the system configuration
preserved in the RTC memory (CMOS type memory) is not the same as the actual
configuration or when the data is lost.
If you press the F2 key as the message instructs, the SETUP screen appears to set
the system configuration.
in the BIOS ROM. The POST tests each IC on the system board and initializes it.
If an error message is
here is no erro message, go to P
indows is properly loaded, go to Procedure 4