Filter
Top Products
Chapter 2 Troubleshooting Procedures
Satellite T130, Satellite Pro T130 and PORTEGE T130Maintenance Manual (960-Q08)
Procedure 2 Message Check
When the power is turned on, the system performs the Initial Reliability Test (IRT) installed
n.
Make sure no floppy disk is in the FDD. Turn on the computer and check the message on the
screen. Wh D, go to Procedure 3. Otherwise, start with
Check 1 be r s as instructed.
Check 1 ages appears, go to Check 2. If the following
Press any key when ready .....
or
Check 2 Using the SYS command of the Free-DOS; transfer the system to the 2.5” HDD.
If the system is not transferred, go to Procedure 3. Refer to the Free-DOS Manual
transferred to the HDD.
If an error m
essage appears on the display, perform Check 3.
Check 3
ert
in the BIOS ROM. When the test detects an error, an error message is displayed on the scree
en an OS starts from the 2.5” HD
low and perfo m the other check
If either of the following mess
messages do not appear, perform Check 3.
Insert system disk in drive
Non-System disk or disk error
Replace and press any key when ready
for detailed operation.
If the following message appears on the display, the system program has been
System Transferred
2.5” HDD(s) and the connector(s) of system board may be defective (Refer to the
steps described in Chapter 4, Replacement Procedures for disassembling.). Ins
HDD(s) to the connector(s) firmly. If it is (or they are) firmly connected, go to
Procedure 3.