Filter
Top Products
58
Getting Started
Adding memory (optional)
5.375 x 8.375 ver 2.3
If no memory slot is available, you must remove a module by
performing steps 2-3 of
“Removing a memory module” on
page 60.
11 Pick up the memory module by its sides, avoiding any
contact with its connector. Position the module toward
the socket, aligning the connector’s notch with the
matching key in the socket.
(Sample Illustration) Aligning the memory module into the
socket
12 Firmly press the memory module into the memory slot’s
socket at approximately a 30-degree angle (to the
horizontal surface of the computer).
(Sample Illustration) Inserting the module into the socket
NOTE
latch
latch
key
notch
connector