Filter
Top Products
User’s Manual 4-9
Operating Basics
How to Enable Fingerprint System Boot Authentication
Settings
It is necessary to first enroll your fingerprint with the OmniPass application
prior to enabling and configuring the Fingerprint System Boot
Authentication System. Check that your fingerprint is enrolled before
configuring the settings. See Manual for Fingerprint Registration/
Enrollment instructions.
1. Click on the System Settings tab in the OmniPass Control Center.
2. Click on PBA Settings.
3. Click on Enroll PBA Authentication Device.
4. Check the Enable System Boot Authentication checkbox.
5. Click on the Next button and after the Congratulations message is
displayed on the screen, click on the Done button to end the PBA
Settings.
The modified configuration for Fingerprint System Boot Authentication
becomes effective the next time the system is booted up.
Fingerprint Single Touch Boot Feature
General
This is a feature that allows the user to complete the authentication for both
the User/BIOS Password (and optionally, the Hard Disk Drive and
Supervisor sub-passwords) and logging on to Windows using only one
fingerprint authentication when booting up. It is necessary to register the
User/BIOS Password and Windows Logon password before using the
Fingerprint System Boot Authentication and this Fingerprint Single Touch
Boot Feature. Please use TOSHIBA Password Utility to register your User/
BIOS Password. If Windows Logon is not the default for your system, see
Manual to register your Windows Logon password.
Only one fingerprint authentication is required to replace the User/BIOS
Password (and, if selected, the Hard Disk Drive and Supervisor sub-
passwords) and Windows Logon password.
How to Enable Fingerprint Single Touch Boot Feature
It is necessary to first enroll your fingerprint with the OmniPass application
prior to enabling and configuring the How to Enable Fingerprint Single
Touch Boot Feature. Check that the fingerprint is enrolled before
configuring the settings. See Manual for Fingerprint Registration/
Enrollment instructions.
1. Click on the System Settings tab in the OmniPass Control Center.
2. Click on PBA Settings.
3. Click on Enroll PBA Authentication Device.
4. Check the Enable Single Touch Boot Feature checkbox.
5. Click on the Next button and after the Congratulations message is
displayed on the screen, click on the Done button to end the PBA
Settings.