Filter
Top Products
E6581343
- 9 -
3.2. STW Control Word Data
PDP002Z supports only speed control mode.
Bit Value Name Note
1
ON
Drive can be started if all other start conditions are fulfilled.
0
0
OFF 1 Normal stop.
1
Operating condition
Drive can be started if all other start conditions are fulfilled.
1
0
OFF 2 Coast stop.
1
Operating condition
Drive can be started if all other start conditions are fulfilled.
2
0
OFF 3 Emergency Stop.
1
Operation
Drive can be started if all other start conditions are fulfilled.
3
0
Inhibit operation Normal stop.
1
Operation condition No function.
4
0
Inhibit ramp-function No function.
1
Enable ramp-function No function.
5
0
Stop ramp-function No function.
1
Enable setpoint Drive can be started if all other start conditions are fulfilled.
6
0
inhibit setpoint Reference frequency is set to zero.
1
Acknowledge Fault reset (0 -> 1)
7
0
No meaning No function.
1
Inching 1 ON Inverter drives with jogging speed.
8
0
Inching 1 OFF
Jogging stop, if "inching 1" was previously ON. Stop drive
accordin
g
to inverter settin
g
p
arameter.
1
Inching 2 ON No function.
9
0
Inching 2 OFF No function.
1
Control from
the automation unit
The control word and frequency setpoint (from Profibus) are
activated.
10
0
No control
The control word and frequency setpoint (from Profibus) are
not valid.
11
-
15
----
Device-specification (Reserved.)