Filter
Top Products
47
5. INSTALL TURBO CHARGER BRACKET.
(a) Install the bracket with short bolt and washer to the
engine (hand tighten).
K: Bolt (5-4)
K: Washer (5-5)
K: Bracket (5-2)
(b) Install the bracket with long bolt, washer and spacer to
the Turbo charger (hand tighten).
K: Bolt (5-3)
K: Washer (5-5)
K: Bush (5-6)
6. TIGHTENING TURBO CHARGER.
(a) Tighten the 4 bolts of the Turbo charger.
Torque: 28 Nm
(b) Bend the locking plates against the side of the bolt.
(c) Tighten the bolt of the bracket to the Turbo charger.
Torque: 20 Nm
(d) Tighten the bolt of the bracket to the engine.
Torque: 16 Nm
7. INSTALL WATER INLET CONNECTION.
(a) Remove the water hose clamps.
R: Hose clamps (2 pcs.)
(b) Remove the water hose.
R: Water hose.
NOTICE: Some coolant will flow out of the cooling
system.
(c) Install additional Hose Heat Protection.
K: Hose Heat Protection. (17-7)
(d) Install hose on turbo inlet side with a clamp.
R: Clamp
Torque: 3 Nm
(e) Install heat protective hose with Lockwire. Use a
stainless steel wire to fit.
K: Hose. (16-3)
NOTICE: Ensure that the clamp is covered by the
sleeve.
K
K
K
K
K
K
4x
A
4x
B
R
R
R
K
R
R
K