TP-Link ADSL2 Modem User Manual


 
110
The device operates in 5.25 ~ 5.35GHz / 5.47 ~5.725GHz/ 5.725~5.850 GHz frequency
range. It is restricted in indoor environment only. This device meets all the other
requirements specified in Part 15E, Section 15.407 of the FCC Rules.
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
RF Exposure Information
This device meets the EU requirements (1999/519/EC) on the limitation of exposure of
the general public to electromagnetic fields by way of health protection.
The device complies with RF specifications when the device used at 20 cm form your
body.
National Restrictions
This device is intended for home and office use in all EU countries (and other countries
following the EU directive 1999/5/EC) without any limitation except for the countries
mentioned below:
Country Restriction
Reason/remark
Belarus Not implemented
Norway
Implemented
This subsection does not apply for the geographical area within a
radius of 20 km from the centre of Ny-Ålesund on Svalbard
Italy
Implemented
The public use is subject to general authorisation by the respective
service provider
Russian Federation
Limited
implementation
1. SRD with FHSS modulation
1.1. Maximum 2.5 mW e.i.r.p.
1.2. Maximum 100 mW e.i.r.p. Permitted for use SRD for outdoor
applications without restriction on installation height only for purposes
of gathering telemetry information for automated monitoring
and resources accounting systems. Permitted to use SRD for other
purposes for outdoor applications only when the installation height is
not exceeding 10 m above the ground surface.
1.3.Maximum 100 mW e.i.r.p. Indoor applications
2. SRD with DSSS and other than FHSS wideband modulation
2.1. Maximum mean e.i.r.p. density is 2 mW/MHz. Maximum 100 mW
e.i.r.p.
2.2. Maximum mean e.i.r.p. density is 20 mW/MHz. Maximum 100
mW e.i.r.p. It is permitted to use SRD for outdoor applications only
for purposes of gathering telemetry information for automated
monitoring and resources accounting systems or security systems.
2.3. Maximum mean e.i.r.p. density is 10 mW/MHz. Maximum 100 mW
e.i.r.p. Indoor applications
Ukraine
Limited
implementation
e.i.r.p. ≤100 mW with built-in antenna with amplification factor up to
6 dBi