TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide
22
3. Select the WAN service type in Figure 4-9. If your ISP provides a PPPoE connection, select
PPPoE optio
n. You can create a service name for the Service Description or leave it the
default name. Click Next.
Figure 4-9
4. Enter the following parameters and then click Next.
Figure 4-10
¾ PPP Username/Password: Enter the User Name and Password provided by your ISP.
These fields are case-sensitive.
¾ PPPoE Service Name: Enter the Service Name if it was provided by your ISP. If you leave it
blank, the default name will be the same as the Service Description on the previous screen.
¾ Authentication Method: Select the Authentication Method from the drop-down list, the
default method is AUTO, and you can leave it as a default setting.
)
Note:
If you are not sure about the PPP IP extension and PPP Debug Mode etc. below, please don’t
select these options.
¾ MTU Size: Maximum Transmission Unit Size. Check this box then you can change the MTU
size. The default MTU value is 1480 Bytes. It is not recommended that you change the default
value unless required by your ISP.