Filter
Top Products
TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide
29
)
Note:
ETH and ATM service can not coexist. If the ATM Interface had configured, you cannot configure
any other WAN service over the ETH Interface until the ATM Interface is deleted.
4.4.2.6 ETH-PPPoE
If your ISP provid
es a PPPoE connection and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of 4.4.1.2
ETH interface.
2. Click the Add button on the screen Figure 4-7 and the following configuration is similar to
PPPoE
over ATM interface (see section 4.4.2.1 ATM-EoA-PPPoE).
4.4.2.7 ETH-IPoE
If your ISP p
rovides an IPoE connection and you want to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of 4.4.1.2 ETH interface.
2. Click the Add button on the screen Figure 4-7 and the next configuration is similar to IP
oE
over ATM interface (see section 4.4.2.2 ATM-EoA-IPoE).
4.4.2.8 ETH-Bridge
If you want t
o adopt the Bridge service and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of 4.4.1.2
ETH interface.
2. Click the Add button on the screen Figure 4-7 and the next configuration is similar to Bridge
over ATM interface (see section 4.4.2.3
ATM-EoA-Bridg).
4.4.3 MAC Clone
Choose menu “Advanced Setup”Æ“MAC Clone”, you can configure the MAC address of the
WAN Interface as shown below.
The WAN Interface List displays the Lay2 Interfaces you have configured on the section 4.4.1
Layer2 Interface
and its default MAC Address. If you have not configured corresponding WAN
Service for the interface on the section 4.4.2 WAN Service, the blank for MAC Address will display
“Need a corresponding WAN Service”.
The last one of WAN Interface List displays your PC’s current address.
Figure 4-20