Filter
Top Products
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Disable port 3:
TL-SG2424(config)# interface gigabitEthernet 1/0/3
TL-SG2424(config-if)# shutdown
flow-control
Description
The flow-control command is used to enable the flow-control function for a port.
To disable the flow-control function for this corresponding port, please use no
flow-control command. With the flow-control function enabled, the Ingress
Rate and Egress Rate can be synchronized to avoid packet loss in the network.
Syntax
flow-control
no flow-control
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the flow-control function for port 3:
TL-SG2424(config)# interface gigabitEthernet 1/0/3
TL-SG2424(config-if)# flow-control
media-type
Description
The media-type command is used to configure the media type of Combo port.
For a Combo port, the media type should be configured before you set its speed
and mode. This command does not apply to TL-SG2452 since TL-SG2452 has
no Combo port.
Syntax
media-type { rj45 | sfp }
90