Filter
Top Products
Example
Enable filter function on interface gigabitEthernet 1/0/2:
TL-SG2424(config)# interface gigabitEthernet 1/0/2
TL-SG2424(config-if)# ipv6 mld snooping filter
ipv6 mld snooping filter-mode
Description
The ipv6 mld snooping filter-mode command is used to configure the filter
mode of the interface. The default mode is accept. To restore the default mode,
please use no ipv6 mld snooping filter-mode command.
Syntax
ipv6 mld snooping filter-mode {accept | refuse}
no ipv6 mld snooping filter-mode
Parameter
accept —— Accept the multicast groups within the filter entry.
refuse —— Refuse the multicast groups within the filter entry.
Command Mode
Interface Configuration Mode
Example
Configure the filter mode as refuse on interface gigabitEthernet 1/0/2:
TL-SG2424(config)# interface gigabitEthernet 1/0/2
TL-SG2424(config-if)# ipv6 mld snooping filter-mode refuse
ipv6 mld snooping filter-id
Description
The ipv6 mld snooping filter-id command is used to specify the filter id on the
interface. To disable this configuration, please use no ipv6 mld snooping
filter-id command.
Syntax
ipv6 mld snooping filter-id filter-list
no ipv6 mld snooping filter-id
Parameter
filter-list —— Specify the filter id list, in format of 1,3,10.
180