Filter
Top Products
Chapter 17 Loopback Detection Commands
With loopback detection feature enabled, the switch can detect loops using loopback detection
packets. When a loop is detected, the switch will display an alert or further block the corresponding
port according to the configuration.
loopback-detection(global)
Description
The loopback-detection command is used to enable the loopback detection
function globally. To disable it, please use no loopback detection command.
Syntax
loopback-detection
no loopback-detection
Command Mode
Global Configuration Mode
Example
Enable the loopback detection function globally:
TL-SG2424(config)# loopback-detection
loopback-detection interval
Description
The loopback-detection interval command is used to define the interval of
sending loopback detection packets from switch ports to network, aiming at
detecting network loops periodically.
Syntax
loopback-detection interval interval-time
Parameter
interval-time —— The interval of sending loopback detection packets. It ranges
from 1 to 1000 seconds. By default, this value is 30.
Command Mode
Global Configuration Mode
115