Filter
Top Products
Inte
rval:
Specify the interval to send ICMP request packets. The default value
is recommended.
16.4.2 Tracert
Tracert test function is used to test the connectivity of the gateways during its journey from the
source to destination of the test data. When malfunctions occur to the network, you can locate
trouble spot of the network with this tracert test.
Choose the menu Maintenance → Network Diagnostics → Tracert to load the following page.
Figure 16-10 Tracert
The following entries are displayed on this screen:
Tracert Config
Destination IP
: Enter the IP address of the destination device
. Both IPv4 and IPv6 are
supported.
Max Hop
:
Specify the maximum number of the route hops the test data can pass
through.
Return to CONTENTS
258