Filter
Top Products
••! •••••••
—Driver installation for DOS environments
! 19
PCMCIA 10/100Mbps Ethernet Card Installation Program
SELECTING DRIVERS
Select the network drivers that you want to install. Use the up and down arrow
keys to highlight the desired item. When a item is highlighted press <Enter>
to select it. If the network driver that you want to install is not in the following
list, press <Esc> to continue.
<Enter> to continue <Esc>to continue <F3> to return to DOS
Netware ODI Driver
Packet Driver
Windows for Workgroups
LAN Manager
Artisoft LANtastic
After selecting the network operating system, the INSTALL pro-
gram will copy and modify files on your boot drive. Your
CONFIG.SYS file will also be modified to include the Enabler
Driver. You should see the following message if the installation
has been successful:
PCMCIA 10/100Mbps Ethernet Card Installation Program
INSTALLATION SUCCESSFUL
INSTALL has created/modified your AUTOEXEC.BAT and CONFIG.SYS file
to enable the PCMCIA 10/100Mbps Ethernet Card. The original files have been
renamed to AUTOEXEC.PCM and CONFIG.PCM. If you have any problems
with the new CONFIG.SYS file when you reboot your computer, you should
restore the original files.
Remove the Driver Disk and reboot your computer now.
Press any key to return to DOS
Custom configuration
To perform a custom installation, you need to select the Custom
Configuration Menu after you begin the INSTALL program.
After selecting the Custom Installation Menu, you see a series of
submenus prompting you to select an IRQ and I/O address.