Filter
Top Products
••! •••••••
—Driver installation for DOS environments
! 23
The Install program will automatically add a line to your
CONFIG.SYS file using the following syntax and format:
DEVICE=[path_name]CARDGO.EXE [/
IRQ
=xx] [/
IO
=xxx][/MEM=xxxx][/?]
where
[/IRQ=xx]
Specifies the hardware interrupt of your card. Default
value is 5.
Valid IRQs are 3, 4, 5, ,9, 10, and 11.
[/IO=xxx]
Specifies the I/O address. Default value is 300.
Valid port addresses are 300, 320, 340, 360, 240, and
280.
[/MEM=xxxx]
Specifies the memory address. Default value is
D400H.
Valid memory addresses are D000H, D400H, D800H,
and DC00H.
[/?]
Displays all possible command syntax.
You can also run CARDGO.EXE by typing “CARDGO” at the
DOS prompt or by including it as a line in your
AUTOEXEC.BAT file.
After you executed CARDGO.EXE, you will see a display similar
to the following indicating that the installation was successful:
Socket
:0
IRQ Number
:05
I/O PORT Base
: 300H
MEM Base :
D000H
The list of error messages the client driver may display and the
correction methods suggested are given in Appendix B.