Filter
Top Products
PWR6: Power Connector for Tyan M1221 only (4Pin x 2)
Signal Pin Pin Signal
GND 1 5 +12V
GND 2 6 +12V
GND 3 7 +5V
GND 4 8 +3.3V
PWR2: PWR Main Connector
P1 +12V
P2 +12V
P3 +12V
P4 GND
P5 GND
P6 GND
Signal Signal
P7 GND
P8 Neutral
P9 90~264V
We suggest using a 1000W or higher power supply; this of course depends on
how many devices you attach. A 1000W is probably sufficient for systems
however a higher wattage solution may be needed if the system is fully loaded.
Look to the www.tyan.com website for further information.
NOTE
YOU MUST unplug the power supply before plugging the power
cables to motherboard connectors.
2.15 – Finishing Up
Congratulations on making it this far! You’re finished setting up the
hardware aspect of your computer. Before closing up your chassis, make
sure that all cables and wires are connected properly, especially IDE cables
and most importantly, jumpers. You may have difficulty powering on your
system if the motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, you can find
help by asking your vendor for assistance. If they are not available for
assistance, please find setup information and documentation online at our
website or by calling your vendor’s support line.
Pin 7: GND
Pin 8: Neutral
Pin 9: 90~264V
33