Filter
Top Products
3.7.2 IDE Configuration Sub-Menu
You can use this screen to select options for the IDE
Configuration Settings. Use the up and down <Arrow> Keys to select
an item. Use the <Plus> and <Minus> Keys to change the value of
the selection options.
BIOS Setup Utility
Main Advanced PCI/PnP Boot Security Chipset Exit
IDE Configuration
Onboard IDE Controller
Serial-ATA Devices
nVidia RAID Setup
Primary IDE Master
Primary IDE Slave
SATA0 (Dev5, Func0)
SATA1 (Dev5, Func0)
SATA2 (Dev5, Func1)
SATA3 (Dev5, Func1)
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA (PI) 80Pin Cable Detection
[Enabled]
[Device 0/1]
[Disabled]
[35]
[Host & Device]
While entering setup,
BIOS auto detects the
presence of IDE
devices. This displays
the status of auto
detection of IDE
devices.
← → Select Screen
↑↓ Select Item
+/- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Feature Option Description
IDE Configuration
Enabled
Onboard IDE Controller
Disabled
Enable/Disable onboard IDE controller.
Device 0/1
Disabled
Serial-ATA Devices
Device 0
Configure serial ATA devices.
Disabled
Hard Disk Write Protect
Enabled
Enable/Disable device write protection.
This will be effective only if device is
accessed through BIOS.
IDE Detect Time Out
(Sec)
0~35
(at 5 interval)
Select the time out value for detecting
ATA/ATAPI device(s).
Host & Device
Host
ATA (PI) 80Pin Cable
Detection
Device
Select the mechanism for detecting
80Pin ATA(PI) cable.
40