Filter
Top Products
12
Set-up (continued)
Compact IC unit (sold separately)
Please ask your dealer for the Compact IC unit
connection.
Connect the compact IC unit to the host computer with
the interface cables which are commercially available.
Interface cable
(Commercial item)
1. Set up the unit joint plate which comes with the
laminator (optional). Mount the printeron to joint
plate.
CAUTION
FRONT
FRONT
XIDi
Printer
Joint Plate
Laminator(ILU)
2. install the laminator
Be careful not to pinch your finger when installing.
Memo
If the mounting is uneven, the card would not be
transported smoothly. be sure to fit the units right
in. Always install the unit at a holizontal and hard
surface location
9 pin
9 pin
Connecting cable
Tight the screw after connecting
OPTION2
PRINTER
Compact IC unit
The laminator is sold separately, as a specialized
optional device for the printer. Consult your dealer for
more details.
WARNING
• Make sure that the power switch is turned
OFF and the AC cable is detatched from
the plug, before connecting and
disconnecting the laminator. Otherwise
electric shocks, fires or malfunction of the
product may occur.
• Using laminator other than those specified
may cause electric shocks, fires or
malfunction of the product.
Connecting the Laminator
Electric
shock
CAUTION
Make sure to tighten the screws of the interface cables.
3. Install the unit connecting cable.(optional)
As shown in the diagram, connect the cable to the
OPTION 2 external connection terminal of the printer
and the PRINTER external connection terminal of the
laminator.