Filter
Top Products
46
Turnover section [Jam (turnover)]
1. Open the printer door and remove the ink ribbon
cassette.
See p.15 in this manual.
2. Remove any jammed cards.
Retransfer section [Jam (transfer)]
1. Open the printer door and remove the retransfer
film cassette.
See p.17 in this manual.
2. A jog lever are supplied as standard.
The jog lever are attached to the center of the card tray
.
Turn the tabs in the arrow direction and take out the jog
lever and removal stick.
3. Turn the jog dial to move the card to the position
where it becomes visible.
Turn the jog dial with the attached jog lever.
4. Remove the card.
Remove the card.
Some parts inside the printer may be
hot. Be careful when removing the card.
CAUTION
• If the jammed cards come out of the turnover table,
push them back into the table, and rotate the table
slowly (as it is positioned vertically) until the table is
located so that the cards can be taken out.
CAUTION
• When rotating the turnover table, be careful
not to touch the metal edge. Wear a glove
for this work.
Injury
• If you can pull out the jammed cards, take them out.
Jog lever
Troubleshooting (continued)