Filter
Top Products
35
Operation (continued)
Coercivity setting mode
Set coercivity for writing data on the ISO compatible
magnetic stripe card.
>MG ISO Type
Lo-Co
EXIT
ENTER
Exit user mode
Press to select the setting and press to save.
(The electronic beep sounds.The beep will not sound
if the buzzer mode setting is set to off.)
Lo-Co
238×10
2
[A/m] (300 [Oe])
Hi-Co
218×10
3
[A/m] (2750 [Oe])
Non-contact IC antenna setting mode
To use non-contact IC cards, set the antenna position
at which the cards stop.
>IC Contact Pos.
None
EXIT
ENTER
Exit user mode
Set IC contact
position:
3 settings
Press to select the setting and press to save.
(The electronic beep sounds.The beep will not sound
if the buzzer mode setting is set to off.)
None
No contact
Ext. Unit
An IC unit contact is being used
Built-in
A built-in contact is being used
IC contact setting mode
When using IC cards, specify the contact position to
stop the cards.
Test print
Test print is provided for printing a test pattern
contained in the printer (there is only one pattern).
Operating the printer independent of the host computer
enables you to find out the source of trouble if there is a
problem in the system.
>IC Antenna Pos.
None
EXIT
ENTER
Exit user mode
Non-contact IC
antenna position:
3 settings
Press to select the setting and press to save.
(The electronic beep sounds.The beep will not sound
if the buzzer mode setting is set to off.)
None
No antenna
Ext. Unit
An IC unit antenna is being used
Added on
A compact IC unit is being used.
>Test Print
OK?
Printing..
ENTER
EXIT
Exit user mode
Press to carry out test printing.
(The electronic beep sounds.The beep will not
sound if the buzzer mode setting is set to off.)
Transport mode
To set the transport mode.
CAUTION
When shipping or moving the printer,
you must set the transport mode. If the printer is not set
the transport mode, it may have a damage.
>Transport mode
OK?
ENTER
EXIT
Please,
Power off
Exit user mode
Press to carry out transport mode.
(The electronic beep sounds.The beep will not
sound if the buzzer mode setting is set to off.)
Please turn off the power.
Turnning on the power, then the
transport mode is canceled.
A single-sided color pattern is printed. When test
printing is completed, the unit will automatically return to
ready staus.
Unit No Setting
Set Unit No.of the printers to be connected
>Unit No;
No.1
EXIT
Unit No:
7 settings
ENTER
Please,
Power off
After that press
EXIT
,Then the message is displayed as shown below.
Exit user mode
Turn off the power
And then by turning on the power,
Unit No. setting mode is cancelled.
(The electronic beep sounds.The beep will not
sound if the buzzer mode setting is set to off.)
Press to select the setting and press to save.