Filter
Top Products
40
5. Set the card on the card tray.
Place the card in right direction. See p.21.
6. Press the ENTER button, select “MG Head” with
the ↑ or ↓ button, and press the ENTER button.
7. When the cleaning card is discharged from NG
card discharge slot, turn off the power of the
printer. Wait for 10 seconds before turning on the
power again.
>>MG Head
OK?
Cleaning..
ENTER
Replace the magnetic head cleaning
card when it gets dirty. A dirty card may pollute the head
and cause damages to the head.
Consult your dealer on the alcohol and cleaning card.
CAUTION
Once printer servicing and cleaning
have been completed
Once servicing and cleaning of the printer have been
completed, check to make sure that all parts have been
replaced properly.
Improper replacement of parts may result in the power
not turning on or in operating errors.
Periodical Maintenance
Periodical maintenance by the service personnel is
recommended to avoid print error and failure.
Consult your dealer for maintenance period and cost.
Cleaning of the bobbin holders
Dirt on the bobbin holders may appear on the card or
the film, cause defects on the card. Clean the bobbins
when replacing ink ribbon or retransfer film.
1. Remove the cassettes of ink ribbon and retransfer
film.
See p.15 and 17 of this manual.
2. Wipe 4 bobbin holders with “Kim-Wipe” soaked
with absolute alcohol(ethanol)
Care and Cleaning (continued)