Filter
Top Products
32
Retransfer mode setting
>Retransfer>
>>Temp.Level
>>Speed (Front)
0(Standard)
-2
ENTER
ENTER
ENTER
ENTER
RESET
ENTER
MENU
MENU
MENU
EXIT
EXIT
EXIT
EXIT
ENTER
EXIT
RESET
ENTER
MENU
EXIT
ENTER
>>Media Type
Std(1000/roll):0
>>Speed (Back)
-2
MENU
EXIT
MENU
>>Standby Mode
Front Wait
Set retransfer film Set film type
Two types of frame settings (1000 or 750 frames per film)
•
Set to adjust the retransfer film specification.
Press to select the setting and press to save.
*After exiting the user mode, press and then press
to initialize.
If initialization is not carried out, the film type setting will have no effect on
the printer.
Set the retransfer temperature.6 gradations can be set
(from –3 or +2, the larger the value the higher the temperature)
•
Retransfer may be not performed well depending on the
cards. Increase the temperature level step by step until the
card can be printed clearly.
Press to select the setting value and press
to save.
*After exiting the user mode, press and then press
to initialize.
If initialization is not carried out, the temperature will have no effect on the
the printer.
Set the retransfer speed: 13 gradations can be set
(from –10 to +2, the larger the value the faster the speed)
•
Partial incompletions may occur depending on the cards
during retransfer. The performance is increased as the
value is lowered. Specify the value mainly onthe retransfer
roller temperature setting and use the speed setting for
fine adjustments.
Press to select the setting value and press to save.
Set the reverse retransfer speed:13 gradations can be set
(from –10 to +2, the higher the value the faster the speed.)
•
Double-sided printing results in a warp depending on
the cards. Change the speed to correct it.
Press to select the setting value and press
to save.
Set the way of the peeling off the retransfer film
2 settings[On and Off]
Depending on the card used,peeling off the retransfer filmmay not be
complete.
For the cards with JIS magnetic stripes,setting "On" is recommended.
•
When setting "On",printing time will be longer by about1,5s
•
No mprovement is expected for the cards with ISO magnetic stripes.
Standby selection :2 settings[Front Wait and Back Wait]
In case of both side printing with optional
unit connected, select either one of the card sides for standby.
Press to select the setting value and press
to save.
Exit user
mode.
(The electronic beep sounds .The
beep will not sound if the buzzer mode setting is set to off.)
(The electronic beep sounds .The beep will
not sound if the buzzer mode setting is set to off.)
(The electronic beep sounds .The beep will not sound if the buzzer
mode setting is set to off.)
(The electronic beep sounds .The beep will not sound if the buzzer
mode setting is set to off.)
(The electronic beep sounds .The beep will not sound if the buzzer
mode setting is set to off.)
ENTER
Press to select the setting value and press to save.
(The electronic beep sounds .The beep will not sound if the buzzer
mode setting is set to off.)
>>MG Print(JIS)
Off
Change settings according to the retranfer film and card used.
Operation (continued)