Filter
Top Products
59
Programming Talkgroups
For many of the trunk scanning features to operate, you need
to program the scanner with the talkgroup ID’s. Each bank
can store up to 100 talkgroups in 10 ID groups of 10
talkgroups each. Group similar talkgroups together in the
same ID group. When scanning, you can turn ID groups on
and off with a quick keypress.
Storing Known Talkgroups
Follow these steps to store talkgroups you have gotten from a
list.
2:SCAN OPTION → 2:TRUNK → Select the bank
→ 3:TALK GROUP
1. Use the scroll bar to select the talkgroup to program, then
press E.
2. Select 1:ID and press E.
3. For Type 2/Digital systems, enter the up to 5-digit
talkgroup ID, then press E.
For Type I systems, enter the 3-digit fleet, for the
dash, then the subfleet number.
For EDACS systems, enter the two-digit agency, for
the dash, then the fleet and subfleet number.
For LTR systems, enter the area code, , home
repeater number, , ID number, then E.
Note: If you replace an existing ID, the alpha tag is also
deleted.
4. Select 2:ALPHA TAG and press E.
5. Enter the alpha tag for the talkgroup.
Note: The alpha tag defaults to the numeric talkgroup ID.
6. If you want the scanner to beep three times to alert you
when the talkgroup is active, select 3:BEEP ALERT and
press E; then, select 1:ON.
7. Press MENU/BACK.
Repeat this procedure for each talkgroup in the system.
Storing Found Talkgroups
While you are ID Searching (see “Searching for Active
Talkgroups”), you can quickly store an active talkgroup ID into
an ID memory.
.
.
.
.
BC296D(NEW) 10/16/03 6:35 PM Page 59