Uniden UBC 120XLT Scanner User Manual


 
<:
."." -. ~ ---,;
I
=-=
-==
Setup
The USC 120XLT comes with a rechargeable Nickel-Cadmit
Battery Pack. When fully charged, this Battery Pack will
supply up to 12 hours of dependable use. (Withthe Squelch
control in "closed" position.)
I
Before using the USC 120XL T for the first time, or whenever
the LOW BATTERY Indicator appears on the LCD display,
you should fully charge the Battery Pack.
Note: When the Battery Pack is Iow, the Low Battery
Indicator will start to blink. After about 10 minutes, the
scanner willshut itself off to prevent the battery from
becoming completely discharged.
Before charging, you must first installthe Battery Pack
accordingto the steps below.
Charging the Battery Pack
1. Plug the AC Adaptor/Charger (AAD-2500U) into the
Charging Jack located on the Left side of the
UBC 120XLT
.(You can use the scanner while it is
charging.)
WARNING! Useonly an AAD-2500UAC Adaptor/
Charger, (or one of the optional Cigarette
Lighter Power Cords listed on page 26). Any
other AC Adaptor or external cord or power plug
having over-voltage or reversedpolarity can
cause overheating or damage to the circuitry.L-,
Plug the AC Adaptor/Charger into a standard AC outlet.
2.
To fully charge the battery, leave the Adaptor/Charger
connected for 14 to 16 hours.
3. When charging is complete, disconnect the Adaptor!
Charger from the AC outlet and from the Battery Pack.
Note: Disconnect the AC Adaptor/Charger from the unit
during a power failure.
Mounting the Flexible Antenna
Place the end of the antenna onto the BNC connector on top
of the scanner and turn clockwise until tight.
10
r