Filter
Top Products
!;
.~
-
Programming Channels
Before you can scan, you must program the channels within a
bank. You can store one frequency per channel, up to 100
channels.
Note: If appears on the display (keypad Locked),
unlock the keypad by pressing and holding (LocK)until
disappears and you hear two beeps.
There are two ways to program a channel:
. Manually select a channel and frequency, using the
numeric keypad.
. Search a band to find an active frequency, and then
directly store it into a selected channel. (See the
Search section, page 21.)
Programming By Manual Entry
1. Selecta frequency.
Example: Program 125.2500 MHz into Channel 18.
2. Make sure the scanner is in the SCAN Mode. If it is in
the SRCH Mode, press @.
3. Press ~ to stop scanning.
i
!
i
"I
i
!
i
.i
4.
Press CDQ)@ to go to Channel 18.
5.
Enter the frequency number using the numeric keypad.
(Be sure to include the decimal point.) As soon as you
enter the first digit of the frequency, the channel number
begins ,to blink.
eD CD CD 0 CD CD.
BANK \ ~I
-:lB~725.2500
I 1\
HOLD
If you make a mistake and want to clear the entry, press
0 twice and re-enter the frequency.
14
,"'---,-,
I